Hello,
Recently i created 3 CLPs that works differently with each other :
CLP 1: Turning off a MIMIX Data Group. Clearing a Target Library, Restoring Target library using *savf from Source
CLP 2: Starting a Data Group using specific Sequence and Receiver
CLP 3: Running an Audit Rule in the said data group
I don't mind running all three seperately but is it possible to make it sequential ?
Like, after all the stuff in CLP 1 gets done it continues with CLP 2 ?
*Same thing on the CLP 1 is how i make the RSTLIB didn't run immediately without confirming that the CLRLIB already cleared the library until theres nothing left
Thanks
Recently i created 3 CLPs that works differently with each other :
CLP 1: Turning off a MIMIX Data Group. Clearing a Target Library, Restoring Target library using *savf from Source
CLP 2: Starting a Data Group using specific Sequence and Receiver
CLP 3: Running an Audit Rule in the said data group
I don't mind running all three seperately but is it possible to make it sequential ?
Like, after all the stuff in CLP 1 gets done it continues with CLP 2 ?
*Same thing on the CLP 1 is how i make the RSTLIB didn't run immediately without confirming that the CLRLIB already cleared the library until theres nothing left
Thanks
Comment