Hi, I've been using this successfully between two ofo our LPARs but have a few questions;
1. The job QNMAREXECD /QUSER seems to continually run even though it doesn?t show in active jobs.. When the job runs, I see in the job log entries from previous remote requests which is a little misleading. Is there a way of forcing each remote call to have its own job and joblog?
2. The remote call I?m executing is a RSTLIB command with *print QPRINT but I can?t find the print anywhere. Where does the output go?
Basically there doesn't see to be anything on the destination LPAR about what has run.
Thanks
1. The job QNMAREXECD /QUSER seems to continually run even though it doesn?t show in active jobs.. When the job runs, I see in the job log entries from previous remote requests which is a little misleading. Is there a way of forcing each remote call to have its own job and joblog?
2. The remote call I?m executing is a RSTLIB command with *print QPRINT but I can?t find the print anywhere. Where does the output go?
Basically there doesn't see to be anything on the destination LPAR about what has run.
Thanks
Comment