If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
We have a spoolfile which uses *AFP to add a barcode to a report. Ideally, I'd like to do something like CPYSPLF to route this to a fax machine. CPYSPLF recognizes the file is not of type *SCS and thus fails.
what are you using to convert to the pdf document? the product I pointed you to actually converts afpds to pdf document including the overlays and bar codes.
You are correct, it does convert to PDF, but drops the overlays and barcode that we add to the report.
SCS spoolfiles are ok, it's just this special device type for *APFDS which cause the challenges.
Thanks.
dhuesman, you are right CPYSPLF has a problem with *AFPDS types. I have been wrestling with the same a while ago until I figured that CPYSPLF works well with *SCS types and not *AFPDS.
CVT2PDF supports only *SCS types.
If you are able to do much with *AFPDS some way, do enlighten us,
Comment