If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The easiest way that comes to mind is to do a DSPPFM
DSPPFM FILE(QGPL/PROOF)
Press F10 to get HEX (Then F11 if you want over and under)
The other option is to use a Hex editor on the PC side
Because that's how you change the colors of the source in SEU, by inserting hex codes in the source that correspond to the colors used by the 5250 data stream.
Michael
"Time passes, but sometimes it beats the <crap> out of you as it goes."
If you want to add color in SEU and you are using Client Access, there is an easy way to set up the hex codes in the keyboard map so you don't have to worry about getting into hex mode to change them. There are some instructions in the code samples in the "Other" section about 7/8 the way down I attached a screenshot of how I use it.
Comment