Hi All:
What is the proper qsh syntax on the following....I've tried
chgvar &lecmd value('/QNTC/FRED/common/"Vendor Files"/"Vendor ABC01 9-07-2010"/ABC01CensusSelect.accdb')
chgvar &lecmd value('"/QNTC/FRED/common/Vendor Files/Vendor ABC01 9-07-2010/ABC01CensusSelect.accdb"')
and about a dozen other variations on the above.
The qsh error is " qsh: 001-0018 Error found running command " .....Permission Denied
My profile has full permission (RWX) and matches my I5 profile & password
The job log is:
Is that not the correct method of executing MS Access?
Any insight is appreciated
Thanks
GLS
What is the proper qsh syntax on the following....I've tried
chgvar &lecmd value('/QNTC/FRED/common/"Vendor Files"/"Vendor ABC01 9-07-2010"/ABC01CensusSelect.accdb')
chgvar &lecmd value('"/QNTC/FRED/common/Vendor Files/Vendor ABC01 9-07-2010/ABC01CensusSelect.accdb"')
and about a dozen other variations on the above.
Code:
dcl &lecmd *char 1024 chgvar &lecmd value('/QNTC/FRED/common/"Vendor Files"/"Vendor + ABC01 9-07-2010"/ABC01CensusSelect.accdb') qsh cmd(&lecmd) endpgm
My profile has full permission (RWX) and matches my I5 profile & password
The job log is:
Message ID . . . . . . : QSH0005 Severity . . . . . . . : 00
Message type . . . . . : Completion
Date sent . . . . . . : 02/15/11 Time sent . . . . . . : 11:40:26
Command ended normally with exit status 126.
Message type . . . . . : Completion
Date sent . . . . . . : 02/15/11 Time sent . . . . . . : 11:40:26
Command ended normally with exit status 126.
Any insight is appreciated
Thanks
GLS
Comment