ibmi-brunch-learn

Announcement

Collapse
No announcement yet.

Updating network printer IP

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Updating network printer IP

    Hi all,

    My company was acquired, new company is changing the IP addresses of everything.

    The AS400 and 4 Kyocera printers used to be on the same subnet (192.168.100.0/24).
    Now the AS400 is on 172.25.1.0/24 and the printers are on 172.25.4.0/24.

    So I followed these steps:

    Code:
    1) WRKWTR and do a #4 to End the writer
    2) WRKCFGSTS *DEV *PRT and use #2 to vary off the device, then #8 to Work with description then #2 to change, then page/roll and change the IP
    3) Vary the device on
    4) wrkwtr and start the print writer
    When I start the writer it looks like it's going to work, however, nothing prints and after a short time the writer status reverts to END on it's own.

    I can ping the printers from the AS400... I'm really stumped at this point.

    EDIT: Nevermind.... the SNMP name on the printers were changed and apparently that matters haha.
Working...
X